1/2 NPT FEMALE PLUG
Cap diameter 1/2 NPT - 20.95mm with female head.
Cap diameter 1/2 NPT - 20.95mm with female head.
Relay 12 Volt 3 terminals isolated by the base.
Cap diameter 3/4 NPT - 26.44mm with female head.
Cap internal diameter 34mm.
Cap diameter 1/2 NPT - 20.95mm with male head hexagonal 6 pans.
Cooling connection at 90° dimension 3/4 X 3/4.
For durite diameter 19mm.
Filetage: 3/4
Durite: 19mm
Alternative 55 amps for mounting with V-belt (non-serpentine) with an internal regulator.
Alternator 12 Volt 55 Amp for Volvo Penta and WTO engine with a fine belt.
Alternative 12 Volt 70Amp for the WTO engine with an internal controller and a mass installation to replace the former Prestolite mountings with external regulator.
V-belt 9.5mm wide and 1013mm long.
Full bearing pad set 0.10 for Ford 302.
Full bearing pad set 0.20 for Ford 302.
Full bearing cushion set 0.30 for Ford 302.
Standard Ford 302 complete bearing pads set.
Full set of Ford 5.8 litre engine bearing pads for repair 0.25 mm.
Complete set of bearing pads for GM base V8 engine 0.20.
SEALED POWER connection lubricant.
Recommended for cushions, bearings, valve rods, buttocks.
It increases the load capacity of the engine oil during rodging to avoid gripping.
Contains special additives that resist extreme pressures.
Based on oil, it works as an additive for oil and does not affect its viscosity.
113.4 g bottle (4 oz).
Low-pressure electric gasoline pump for engine installation injection and carburettor.
Right dimension cooling connection 3/4 X 1".
For diameter 25mm.
Filetage: 3/4
Durite: 25mm
Key contactor 5 plots - 3 positions.
OFF-ON-START
Relay 12 Volt 4 terminals for starter or trim BRP.
Isolate from the base.