recherche avancée

Retrouvez facilement votre pièce détachée de bateau

Reset my choices

Turbo collar

Filtres

Catégories

Categories

Turbo collar

Reset this group

Moteur

Feed

motor base

Fuel

Diesel

Brand

Displacement

Model

cid

Family

Helix

Off/inboard

Injection

Number of cylinder

room for

Base
Engine

transmission type

Cycle

Commercial designation

Attributs

Brand

Turbo Necklace for Yanmar, Volov Penta, Mercruiser

Choose the turbo collar that matches your Yanmar, Volvo Penta or Mercruiser engine.

The correct assembly of a turbo collar is essential for optimal operation while avoiding premature failure.It is designed to clamp the corresponding flanges together while allowing a movement by expansion and vibration.

Viewing 1 → 4 of 4 product(s)

TURBO CLAMP VOLVO D6 - YANMAR

TURBO CLAMP VOLVO D6 - YANMARDAM MARINE

Ref. VP25767

Connection collar between exhaust elbow and turbo on Volvo Penta D6 and YANMAR engines.

Livraison express → Tuesday 03 October | Livraison classique → Thursday 05 October

Commandez dans les 13h et 43 minutes

€45.00 €45.00

TTC HT

In stock

COLLAR TURBO VOLVO - YANMAR

COLLAR TURBO VOLVO - YANMARSLP

Ref. VP15765

Clamp for exhaust turbo elbow connection on Volvo Penta and Yanmar engines.

Livraison express → Tuesday 03 October | Livraison classique → Thursday 05 October

Commandez dans les 13h et 43 minutes

€32.00 €32.00

TTC HT

In stock

MERCRUISER TURBO COLLAR

MERCRUISER TURBO COLLARMERCRUISER

Ref. 54/864148A01

Livraison express → Tuesday 03 October | Livraison classique → Thursday 05 October

Commandez dans les 13h et 43 minutes

€26.44 €26.44

TTC HT

In stock

YANMAR TURBO CLAMP...

YANMAR TURBO CLAMP 120650-13450YANMAR

Ref. DM_CR_120650-13450

€34.37 €34.37

TTC HT

On demand

How do you mount your turbo collar?

\n

To mount a turbo collar, the matching flanges must be adjusted and then tighten to a torque of 3.5 NM (Newton-meter).Later, using a rubber mallet, you have to type around the flanges to allow the joints to center completely and get no uneven load.Finally, the clamp torque must be increased to the final setting of 5 NM.

\n

Warning: excessive clamping can damage the collars, flanges and piping!