Timing cover

Kit allowing the installation of an aluminium distribution cardr in combination with the flask and the position sensor of a plastic cardr.

This kit allows to use an engine block intended for an aluminium distribution cardr in combination with an injection system especially intended for a plastic crankcase.

Plastic sensor flask 3 plots

Capteur aluminium flask 58 plots

Plate distribution housing for 4-cylinder and 6-cylinder engines online.

Think about the spi 6936S joint and the AP355 winding joint or the TCS13198 kit.

V6 and V8 engine distribution back on GM basis.

Aluminum distribution housing for 454 and 502 generation engines 6.

Plastic distribution housing for V8 motor without the hole for the vilebrequin position sensor.

Carter including the spi joint and the barrel joint for winding.

Plastic dispenser for V8 motor with hole for the vilebrequin position sensor.

Carter including the spi joint and the barrel joint for winding.

Distribution box for Ford 5 liters and 5.8 liters.

Plastic distribution housing for V6 Vortec motor without hole for the vilebrequin position sensor.

For mounting with the hole you refer to reference 500262.

Plastic dispenser for V6 Vortec motor with drilling for the vilebrequin position sensor.

For holeless mounting you refer to the 500262WO reference

Black distribution housing for GM V6 and V8 engine.

Replacer to be added under reference 9179.

Chrome distribution housing for GM V6 and V8 engine.

Replacer to be added under reference 9179.

Distribution box for 454 and 502 generation 5 engine with a single-piece cranking seal.

Distribution housing for 454 and 502 generation 4.

Aluminum distribution housing for V6 Vortec latest generation multipoint injection MPI - GXI with 58x tooth wheel.