DEMARREUR EVINRUDE BRP E-TEC 40 - 90HP
Démarreur 9 dents pour moteur Evinrude E-TEC de 40 à 90HP entre 2004 à 2011.
Démarreur 9 dents pour moteur Evinrude E-TEC de 40 à 90HP entre 2004 à 2011.
12v 30 amp small pin relay for Volvo Penta 4 cylinder V6 - V8 petrol engines.
Solenoid for large model starters of types DR9597 or ST70.
2 solenoid lengths exist, namely:
- Short height 8 cm for the body
- Long height 10 cm for the body
Information to be specified when purchasing.
Alternateur 12 Volt 65Amp pour moteur Mercruiser essence et diesel.
Pour le montage en application diesel avec poulie double , merci de récupérer l'ancienne.
Par ailleurs pour la conversion des alternateurs diesel obsolètes les supports 806979T et 806980T sont nécessaires.
Alternateur 12 Volt 70 Amp pour moteur PCM, Indmar , Crusader disposant d'une courroie fine.
12 Volt 70Amp alternator with a pulley for a 65mm diameter serpentine belt.
Right cylinder head ignition coil for Indmar Raptor type engines before 2018 with serial number 207510 and lower.
Cylinder numbers: 1 - 2 - 3 - 4
Please note: please compare with reference 597032 because the assembly is different depending on the cylinder head.
Bobine d'allumage pour moteur Mercury et Mercruiser suivants :
Mercury :
- 35, 40, 50, 60Cv 4Temps 4Cylindres EFI à partir de 0P560350 et à partir de 1C104424
- 75, 80, 90, 100, 115Cv 4Temps 2.1L EFI à partir de 2B0950409
- 150 EFI à partir de 1B905505
- 175, 200, 225 3.4L V6 à partir de 2B529482
- 200, 225, 250, 300 4.6L V8 à partir de 2B529482
MERCRUISER :
- 4.5L MPI à partir de 2A441953
- 6.2L MPI à partir de 2A456613
Bobine d'allumage pour Mercury et Tohatsu suivants :
- Mercury : 8 et 9.9HP 4 temps après 2003
- Tohatsu : 8 et 9.9HP 4 temps après 2003
Ignition coil for the following Yamaha and Mercury outboard motors:
Mercury: 2 to 3.3HP 2-stroke
Yamaha: 9.9 to 15HP from 1996 to 2009
Bobine d'allumage pour moteur Mercury Optimax à partir de 2006 suivants :
135, 150, 175 2.5L DFI OPTIMAX
200, 225, 250 3.0L DFI OPTIMAX
Electronic distributor for Ford 351 5.8 liter EFI multi-point injection engine.
Electronic ignition module for Mallory brand igniter.
Module to replace the existing one which cannot convert a conventional igniter.
Use on AP1677EST - RA107039M type igniters.
V6 igniter finger for thunderbolt igniter with 4 fixing screws and a round coil.
Prestolite igniter finger.
Distributor head for Mallory brand distributor.
Inner diameter: 85mm (support groove)
Distributor head for Ford injection engine.
Complete spark plug wire set with 90° ends for Johnson - Evinrude V6 engines from 150 to 235HP.
Set of 6 pieces.