PISTON GM350 - 0.30
Piston for GM V8 engine with 102.35mm bore, 0.30 dimension.
DAM Marine possède plusieurs produits en stocks qui pourraient vous être utiles.
Piston for GM V8 engine with 102.35mm bore, 0.30 dimension.
joint spi avant de vilebrequin pour moteur GM avec carter de distribution en tole.
compatible avec les L4 - V6 - V8 Small Block
Low profile clutch for GM base 4 cylinder engine with 1 piece oil pan gasket.
Kit including all the seals for removing the lower engine.
Pouch including the following seals:
- oil pan gasket
- drain seal
- timing case gasket
- front and rear crankshaft oil seal
- fuel pump gasket
- water pump reassembly seal
- oil pump seal.
Rochester 4-barrel carburetor base gasket with 110 x 145mm center distance, 2mm thickness.
Kit including the oil pan gasket and the necessary screws for reassembly for GM V8 engines before 1988.
Optional mounting allows for a one-piece crankcase gasket for easier installation.
Set of bearings for a connecting rod in dimension 0.20.
Set of bearings for a connecting rod in dimension 0.10.
SEALED POWER assembly lubricant.
Recommended for bushings, bearings, valve stems, rocker arms.
It increases the load capacity of the engine oil during break-in to prevent seizure.
Contains special additives that withstand extreme pressures.
Petroleum based, it works as an additive to oil and does not affect its viscosity.
113.4 g (4 oz) bottle.
Set of rings for a piston in dimension 0.30 with dimensions 2 x 2 x 4.76mm.
Piston ring set for a 0.20 dimension piston for GM 5 liter Vortec engine with thin rings measuring 5/64 x 5/64 x 3/16
Piston ring set for a 0.30 sized piston for a GM 5 liter Vortec engine with thin rings measuring 5/64 x 5/64 x 3/16
Intake gasket kit for 4.3 liter V6 engine with an intake manifold with 8 Vortec series fixing screws.
Rigid intake gaskets compared to part number FP17310.
Set of rings for a standard size GM 5.3 litre V8 engine piston.
Segments with the following dimensions: 1.2X1.5X2.5 mm
Set of segments in dimension 0.40 with the following dimensions: 1.98 x 1.98 x 4.76MM.
Scraper segment depth: 3.20mm