PARAGON CHRISCRAFT 283 REVERSE SEAL
Connecting joint between the Chriscraft 283 engine block and the Paragon inverter.
Connecting joint between the Chriscraft 283 engine block and the Paragon inverter.
Complete seal kit for inverter types:
- HSW450D
- ZF45C
- ZFC-W
- HSW630D
- ZF63C
- ZF88C
Seal kit for PCM 80 series V-DRIVE inverter.
Complete repair kit for Hurth HBW 5 - 50 and 100 inverter including:
- 8 bronze discs .063
- 6 .056 steel discs
Complete reverse disc kit for Velvet inverter.
Kit including:
2 large bronze discs: R160008
1 large steel disc R160009
Complete repair kit including discs and seals for ZF45 inverter - HSW450A-2
Complete repair kit for Hurth ZF HBW10 and HBW150 inverter.
Kit including:
- All reassembly seals
- 8 bronze friction discs, 1.6 mm thick
- 8 steel friction discs, 1.42 mm thick
On the first generation there are inverters with 6 steel discs.
In this case, refer to reference ALT903.
Complete IRM80 inverter kit for PCM type FORD engine with a ratio of 1.23/1.
The IRM40 type inverters are now replaced by more robust IRM80 series inverters.
Kit including the following positions:
- Inverter
- Oil cooler
- Flexible
- Coupling
- Mounting kit
Kit réfection complet pour inverseur de type ZF IRM220 et IRM220A incluant les postes suivants :
- kit joints complet ALT801 - 3205199501
- 22 disques de frictions bronzes - ALT750X - 3205302057
- 24 disques de frictions aciers - ALT750X - 3205302062
- 4 disques de friction bronzes avant / arrière cannelures extérieur -ALT750X - 3205302056
- plaque de pression avant et arrière NON incluses.
Retrofit cooling kit providing better cooling than the original Volvo coolers.
The presence of a larger number of bundles increases the cooling capacity.
Much more economical material than the original Volvo material.
Hardware including installation kit.
Oil cooler for Volvo Penta D4 and D6 engines as a replacement for MOTA brand coolers but at a significantly lower cost.
Cooler with the same thermal characteristics but with a simpler architecture.
The VETUS flexible cable gland used in this system has double lip seals to double the safety and guarantee watertightness.
Shaft diameter: 35 mm
Stern tube diameter: 56 mm
Width: 112 mm
Length: 145 mm
Teflon braid with PTFE impregnation sold by the meter.
Section 6 x 6 mm
22MM CABLE GLAND FOR 39MM Sternpost
Cable glands made of special rubber to resist oils, temperature differences and friction.
Supplied complete and ready to install with protective tab, stainless steel clamps, tube of silicone grease and assembly instructions.
Resin hydrolube ring with the following dimensions in inches:
Shaft: 25.4 mm or 1".
Outside diameter: 38.10 mm or 1-1/2".
Total length: 101.60 mm
Other variations on request.