FILTRE A HUILE INDMAR OEM
Filtre à huile en M22 pour moteurs indmar après 2011 disposant de culasses aluminium types 6L et 6.2L numéro 164786 et avant.

Indmar Marine Engines est une marque présente depuis plus de 45 ans dans l'industrie de la marine intérieure. Leurs moteurs inboards font partie des tous meilleurs du marché.
N'hésitez pas à regarder les pièces proposées par DAM Marine.
Filtre à huile en M22 pour moteurs indmar après 2011 disposant de culasses aluminium types 6L et 6.2L numéro 164786 et avant.
Ignition Coil Power Wires 18-5433.
Harness with black sheath connecting to the HEI distributor plug.
Installation planned for harness with RA101011.
Black socket.
Oil filter for GM base Indmar engines 5.7L, 6L and 6.2L type part number 174786 and earlier.
10 micron fuel decanter filter for Indmar engines based on Ford Raptor 6.2L serial number 164786 and later.
Catalytic converter exhaust elbow gasket for all Indmar 5.7 litre and 6.2 litre engines with ETX CAT cooling.
Oil filter for indmar types Ford Raptor 6.2L in M18.
Joint de thermostat pour moteur indmar.
Elbow joint for indmar base engine Ford Raptor before 2017.
Elbow joint for Indmar engines based on GM.
90° elbow fitting in NYLON, size 3/4 X 5/8".
Thread: 3/4
Diameter: 16mm
Thermostat gasket for Indmar engine.
90° elbow fitting in NYLON, size 3/4 X 1.
Thread: 3/4
Hose: 25mm
Gasket for heat exchanger cover.
Upper and lower thermostat housing for Indmar engine.
Thermostat and cover gasket included.
Hardware replacing old 531402 housings.
Reducer fitting kit allowing the replacement of old fittings removed from the factory.
The allen fitting must be removed on the manifold for installation of this kit.
Oil filter for Indmar engine types Ford Raptor 6.2L.
OEM exhaust elbow for Indmar GM type 5.7 liter engine.
Boat application: Malibu Mastercraft Supra and Moomba.
Elbow outlet diameter 90mm.
Remember to add the AP1499 elbow joint.
Gasket for heat exchanger cover on Mercruiser diesel engine CMD series.
Diameter 126mm.
90° cooling fitting measuring 1/2 x 1 inch.
For 25mm diameter hose.
Thread: 1/2
Hose: 25mm
Indmar specific oil fitting for Jiffy assembly requiring a fitting with an O-ring.
Oil dipstick pull for GM base V6 engine.
Material to be used with reference 551661.
Manifold gasket for Indmar Ford Raptor engines.
Sold individually.
54mm thermostat for Indmar Raptor base Ford 6.2L 160°F engine.
Serpentine belt for Indmar engine types:
- GM 5.7 liters after 2003
- Monsoon 345HP and 350HP
- Hammerhead, Mastercraft and Monsoon after 2005