GM181 PISTON AFTER 1990 - STD
Piston for 4-cylinder 3-litre engine after 1990 with flat top.
Piston in standard dimension 101.60mm.
Piston for 4-cylinder 3-litre engine after 1990 with flat top.
Piston in standard dimension 101.60mm.
Set of rings for a standard size piston on GM or Ford base engines with a bore of 101.60mm.
Segment height: 2 - 2 - 4.8mm
Centering pin for cylinder head plane on GM Small Block GM350 - 305 and V6 engines.
Sold individually.
Complete main bearing set for GM 4 cylinder engine in standard size.
Oil pan screw with shoulder.
Complete camshaft bearing kit for GM181 3 litre 4 cylinder engine.
3/8 NPT - 16.66mm diameter plug with BTR female head.
Longueur sous tête 35mm.
Demandez le délai de réapprovisionnement et le tarif en cliquant sur le bouton « Ask for a quote ».
Un conseiller traitera votre demande dans la journée.
Rear crankshaft oil seal including mounting hardware for multiple GM base 4 cylinder, V6 and V8 engines.
For assembly with a slight flange on the seal, refer to reference 5512.
Rear seal for crankshaft oil seal housing 1 pc.
Set of bearings for a standard size connecting rod with a diameter of 53.34mm and a width of 21.3mm.
Please note that for recent 4-cylinder 3-litre GM181 engines ONLY which have bearings with a width of 19mm, please refer to reference 23-804982.
Fitting allowing the oil filter to be attached to the GM engine block.
Demandez le délai de réapprovisionnement et le tarif en cliquant sur le bouton « Ask for a quote ».
Un conseiller traitera votre demande dans la journée.
Stud kit for fixing the coupling damper including nut and washer.
Stud length: 49mm.
Demandez le délai de réapprovisionnement et le tarif en cliquant sur le bouton « Ask for a quote ».
Un conseiller traitera votre demande dans la journée.
Gasket for tappet cover hatch on GM 4 cylinder engine.
Gasket for GM base engine distributor.
Clamp to hold the distributor of all GM engines.
Oil filter height 13 cm - 13/16 X 16NPT
For an 8 cm high oil filter, refer to reference R134.
Camshaft for GM181 and GM153 4-cylinder engine.
Oil pressure sensor for non- VDO mounting with 2 indicators, dual positions.
Dimensions: 1/8-27NPT - 80PSI
Demandez le délai de réapprovisionnement et le tarif en cliquant sur le bouton « Ask for a quote ».
Un conseiller traitera votre demande dans la journée.
Poussoir hydraulique plat.
Sheet metal timing case for 4-cylinder and 6-cylinder in-line engines.
Consider the 6936S oil seal and the AP355 reassembly seal or the TCS13198 kit.
joint spi avant de vilebrequin pour moteur GM avec carter de distribution en tole.
compatible avec les L4 - V6 - V8 Small Block