Arrangement product list
DIAPHRAGM BRP 0435957
GM V8 BB LOWER ENGINE CLUTCH
GM V6-V8 BREWING PUMP
Circulation pump for circulating water in the engine block.
Installation intended for V6 - V8 engines with a sheet metal or plastic timing case.
Fixing by 4 screws above the timing case.
TE91112 reassembly gaskets included.
For V6 Vortec engines with an aluminum timing cover only, refer to part number W898N.
W898 SERIES BREWING PUMP SEAL
Stirring pump gasket for GM base V6 and V8 engines.
Joint sold individually.
VIS NLA VOIR 800053
Demandez le délai de réapprovisionnement et le tarif en cliquant sur le bouton « Ask for a quote ».
Un conseiller traitera votre demande dans la journée.
SERPENTINE WATER PUMP PULLEY
SCREW 5/16-24 X 3/4
DAMPER GM 203MM - 4.8KG
Damper avant pour montage en bout de vilebrequin disposant d'un diamètre de 203mm.
SERPENTINE CRANKSHAFT PULLEY
Crankshaft pulley for serpentine belt of 5.7 and 6.2 liter engine.
SB BALANCE SCREW KIT
Vis de maintient de poulie damper pour moteur V6 et V8 GM Small block.
SCREW 3/8-24 X 1
CARTER DE DISTRIBUTION GM V8 VORTEC W/O - PLASTIQUE
Carter de distribution en plastique pour moteur V8 ne disposant pas du trou pour le capteur de position du vilebrequin.
Carter incluant le joint spi et le joint torique pour le remontage.
KIT SUPPORT FILTRE A HUILE
Support de filtre à huile pour moteurs base GM V6 et V8 étant installé sur le bas moteur avec maintient par 2 vis.
LONG OIL FILTER
Oil filter height 13 cm - 13/16 X 16NPT
For an 8 cm high oil filter, refer to reference R134.
REAR OIL SEAL CRANKSHAFT GM 4-6-8 CYL 1 PCS - LH
Rear crankshaft oil seal including mounting hardware for multiple GM base 4 cylinder, V6 and V8 engines.
For assembly with a slight flange on the seal, refer to reference 5512.












