FORD V8 460 CONVENTIONAL SPARK PLUG WIRE KIT
Complete spark plug wire set including coil wire for OMC FORD 7.5 litre 460 engine.

Complete spark plug wire set including coil wire for OMC FORD 7.5 litre 460 engine.
Complete spark plug wire set for GM496 8.1 litre V8 engine with 8 coils.
Left cylinder head ignition coil for Indmar Raptor type engines after 2018 with serial number 207510 and higher.
Cylinder numbers: 5 - 6 - 7 - 8
Please note: please compare with reference 597097 because the assembly is different depending on the cylinder head.
Right cylinder head ignition coil for Indmar Raptor type engines after 2018 with serial number 207510 and higher.
Cylinder numbers: 1 - 2 - 3 - 4
Please note: please compare with reference 597100 because the assembly is different depending on the cylinder head.
Ignition coil for Honda BF175 to BF225 engine.
Starter motor for Ford Raptor engine after 2019 in upper part mounting with machining on the front face.
Original Indmar starter.
Large model 9-tooth starter with 2 fixing screws on the same axle.
- Short screw type PG600
- Long screw type PG601
Screws not included.
Universal engine harness for GM carbureted base engines with conventional or Prestolite electronic ignition.
Beam that can be adapted to a multitude of applications.
Motor output connection 8 square male pins.
For a complete hardware assembly to be used in combination with the references:
- 6117-25
- 6107-03
The role of the MAP (Manifold Absolute Pressure) sensor is to measure the air intake pressure as air enters the engine. It will then transmit this information to the engine control unit. The latter can then adjust the amount of fuel injected.
Oxygen sensor for Honda outboard motor.
Cooling sensor for MPI engine.
Temperature sensor present on the head of the diesel filter for Volvo Penta D4 and D6 engines.
Capacitor for Mallory brand igniter.
Distributor head for Ford injection engine.
Ignition coil for Mercury Optimax engines from 135 to 250HP.
12 Volt 65Amp alternator for Mercruiser gasoline and diesel engines.
For diesel application assembly with double pulley, please recover the old one.
Furthermore, for the conversion of obsolete diesel alternators, brackets 806979T and 806980T are required.
12 Volt 70 Amp alternator for Crusader engine - PCM with a pulley for a 65mm diameter serpentine belt.
12 Volt 70 Amp alternator for Mercruiser engine with a 50mm diameter serpentine pulley.
12v 30amp small pin relay for multiple applications, namely:
Volvo Penta
Indmar
Ilmor
4-terminal base-isolated relay for the following Mercury engines:
- 15 to 60HP 2-stroke 2 and 3 cylinders
- Mercruiser inboard
14 tooth starter for the following Mercury outboard motors:
- DFI - OPTIMAX: 115 to 200HP 2.5L SN OT178500 and after - 200 to 250HP 3L SN OT467442 and after
- VERADO: 135 to 350HP after 2005 with a solenoid on the starter.
Solenoid only: SW463
305 mm (12 in.) beam.
To convert the newer 3-pin Packard connector hydraulic lift pump harness to the older 3-pin connector remote control harness.