ALTERNATOR SUPPORT

12V 90Amp alternator for Honda BF200 - BF225 engine.
230Amp alternator for Indmar Raptor Ford based engines types 400, 450 and 575 installed on Moomba and Supra boats.
Material not suitable for replacing a 95AMP alternator.
12 volt 80 amp alternator to replace 60 amp assemblies.
Alternator with the same architecture as the ARC80168 reference, delivering 80 amps and having a double pulley for a classic V-belt.
This replacement involves bringing the assembly initially intended for 60 amps up to standard.
No after-sales service can be taken into account for this development.
12 volt 115 amp alternator for PCM H5 - H6 engine.
Ignition coil for Mercury and Yamaha outboard motors from 25 to 60HP.
High voltage ignition coil for performance applications requiring higher ignition output.
Black epoxy 45000 volts.
Primary resistance: 0.700 Ohms
Ignition coil for Mercury outboard motor type Optimax 2.5 and 3 liters.
Ignition coil for Ford V8 5 and 5.8 liter injection base engine.
Forward - reverse cut-off switch for OMC V6 4.3 liter engine.
Clamp to hold the distributor of all GM engines.
Mallory electronic distributor for Ford 302 5 litre engine with carburetor.
4-wire forward-reverse cut-off switch for OMC base of the following engines:
- 4 cylinders 2.3 and 3 liters 120-140HP
- 4.3 liter V6
Ignition rotor for MSD brand engine.
Distributor head for Volvo Penta engine diameter 73mm.
Ignition harness kit with 6 wires for Mercury V6 225 to 250HP fuel injected or carbureted engine.
Straight male and 90° angled female end piece.
Capteur TPS seul pour potentiomètre de moteur PCM référence RA119004.
TPS Throttle Position Sensor for inboard engines.
The role of the MAP (Manifold Absolute Pressure) sensor is to measure the air intake pressure as air enters the engine. It will then transmit this information to the engine control unit. The latter can then adjust the amount of fuel injected.